Luminex 100 User Manual Version 1.7 - Manual (Page 81)

PN 89-00002-00-063 Rev. A 7 - 1
Maintenance and Cleaning
Proper maintenance and cleaning of the Luminex 100 analyzer
should be performed in order to preserve the analyzer’s longevity
and reliability.The maintenance log at the end of this chapter will
help you to keep track of when maintenance procedures are
performed. It lists and defines the frequency of each task.
This section describes the following maintenance procedures:
• Startup
• Shutdown
• Check Fluid Levels
• Check for Leaks
• Calibrate
• Sanitize
• Clean Accessible Surfaces
• Clean Sample Probe
• Replace Air Intake Filterss
• Replace Syringe Seal
• Clean Luminex 100 Analyzer Ventilation Filter
• Change Sheath Filter
• Change Fuses
• Adjust Sample Probe Vertical Height
D O NOT REMOVE THE ANALYZER COVER !
Startup
‹ Perform the entire startup procedure on a daily basis.
1. Turn on the analyzer and PC.
2. Click Warmup.
7
Warning: When analyzing
potentially infectious biological
samples on the Luminex 100
analyzer, follow proper biosafety
procedures. These safety
precautions should also be taken
when cleaning or maintaining the
Luminex 100 analyzer.