IAI America E-Con - Manual (Page 135)

127
8.
ASEL, PSEL, SSEL
(3) In the case that I/O Points setting is larger than 208 and smaller than 256 points:
They are configured as three remote devices (No. of Occupied Stations: Three Stations)
I/O Parameter
No.14 No.15
DI on the ASEL,
PSEL and SSEL
Side
PLC Side
DO on the ASEL,
PSEL and SSEL
Side
PLC Side
(16) (16) 000 – 015 RY 0 – F 300 – 315 RX 0 – F
(32) (32) 016 – 031 RY 10 – 1F 316 – 331 RX 10 – 1F
(48) (48) 032 – 047 RY 20 – 2F 332 – 347 RX 20 – 2F
(64) (64) 048 – 063 RY 30 – 3F 348 – 363 RX 30 – 3F
(80) (80) 064 – 079 RY 40 – 4F 364 ᫥ 379
RY 40 – 4F
(96) (96) 080 – 095 RY 50 – 5F 380
᫥ 395
RY 50 – 5F
(112) (112) 096 – 111 RWw0 396 – 411 RWr0
(128) (128) 112 – 127 RWw1 412 – 427 RWr1
(144) (144) 128 – 143 RWw2 428 – 443 RWr2
(160) (160) 144 – 159 RWw3 444 – 459 RWr3
(176) (176) 160 – 175 RWw4 460 – 475 RWr4
(192) (192) 176 – 191 RWw5 476 – 491 RWr5
208 208 192 – 207 RWw6 492 – 507 RWw6
224 224 208 – 223 RWw7 508 – 523 RWw7
240 240 224 – 239 RWw8 524 – 539 RWw8
256 256 240 – 255 RWw9 540 – 555 RWw9
Impossible setting
 ℞℣⅃ℍ  ℞℣ℾℍ
Impossible setting  ℞℣⅃B  ℞℣⅃B
* The ports in gray column show the system domain for the remote device station on the PLC side, so any of them can
not be used as an I/O port.
* In the case of three occupied stations, 12 words for each input and output are allocated for the data register on the PLC side
(10 words for ASEL, PSEL and SSEL). Take care of the duplicated use of the data registers on the PLC side.
The ports in gray column show the system area for the remote device station on the PLC side, so any of them can