IAI America CON-PG - Manual (Page 180)

174
7. Operation of MEC Controllers
[2] Basic operation
Touch the value field of each setting item such as position.
When the numeric keypad is displayed, enter a desired
value and then touch [ENT].
Touch ether of [Start], [Int] or [End] and the display moves
to the setting screen corresponding to start position, end
position or intermediate position.
(Note) The positions must satisfy the following relationships: Home Start position Midway
position End position
Touching [Jog] switches to jog operation.
[Manual axis operation (jogging/inching)]
You can load position data via manual axis operation (jogging/inching).
Operations on the manual axis operation (jogging/inching) screen
While any of these buttons is touched, the axis jogs in the
direction of the arrow. The axis moves at 1 mm/s in the
low-speed mode, 10 mm/s in the medium-speed mode, or
50 mm/s in the high-speed mode.
Select one of the speed.
While any of these buttons is touched, the axis inches in
the direction of the arrow. Select 0.01 mm, 0.1 mm or 1.0
mm as the inching distance.
[Servo ON]
Touching [Motor Power ON] when the motor power (servo)
is turned off turns on the motor power (servo) and the O
lamp will become lit. Touching [Motor Power OFF] when
the motor power (servo) is turned on turns off the motor
power (servo) and the O lamp will become unlit.
[HOME]
Touching [HOME] before the home return is completed
causes the axis to return home and the O lamp will
become lit.