IAI America CON-PG - Manual (Page 202)

196
7. Operation of MEC Controllers
(Stop mode) Displayed for PMEC controllers
Set whether to implement servo stop based on the full servo control method or complete stop without
servo control when the actuator stops.
(Note) When this parameter is changed, the new setting will not be reflected until the position data is
written to the controller again.
(Current limiting value while stopped after positioning) Displayed for PMEC controller
Set the current limiting value to be applied while the actuator is stopped after positioning.
(Current limiting value during home return)
Set the current limiting value to be applied during home return operation.
(Position execution wait time during continuous operation)
This parameter is not used with PMEC and AMEC controllers.
(Soft limit)
Set the positive soft limit.
(Home return offset)
Set the offset for home return.
(Home return direction)
Set whether to perform home return in the motor direction or counter-motor direction.
The home return direction cannot be changed for some actuators, such as rod-type actuators.
(Position edit password)
Set the password for editing position data.