ZOLL M Series Defibrillator Rev YH - Manual (Page 95)

C-3
4. Activate the communication software on the receiving
PC. If not done already, prepare the host system (PC)
to receive a data file by entering the communications
settings as shown on the previous page.
5. Press the Send softkey. Uploading begins in about
one second. The Upload screen displays a progress
bar that indicates the percentage of data transferred
to the PC. To stop data transmission, move the unit's
rotary switch to OFF.
Note: Card data must be re-transmitted if the unit is
shut off before all data stored in the card has
been transmitted.
6. Following a successful transmission, the unit displays
the Card Uploaded screen. To upload another card,
remove the current card, insert a new card, and press
the Send softkey again. (The Send softkey appears
when the new card is inserted.)
After transmission, file names created by the
communications program on your PC have the following
format:
ZLssssssss_YYYYMMDD_HHMMSSL.crd
where:
Example: ZL12345678_20010825_183005A.crd
Unit 12345678 August 25, 2001, 6:30:05 PM.
Troubleshooting
(See Display Message table below for additional
Troubleshooting information.)
If the card is not inserted properly into the PCMCIA card
slot when data transmission is attempted, the following
screen displays. Check the insertion of the card. The
card may need to be reinserted so that it is seated
properly.
If during transmission, the PC halts its reception of data,
a “Host Fault” message appears and the upload stops.
ssssssss = Unit serial number
YYYYMMDD = Year, month and day of transmission
HHMMSS = Hour, minute, and second of
transmission
L = A unique identifier associated with the
file that increments sequentially through
the alphabet (e.g., A, B, C, etc.)
Uploading
20%
Upload
Power Off to Abort
Card Uploaded
Erase or Insert Next Card
Upload
Erase* Return
Card Removed
Insert Card to Upload
Upload
Return
Host Fault
Upload Aborted
Send
Upload
Erase* Return