ZOLL Propaq M Rev A - Manual (Page 54)

50 9650-0804-01 Rev. A
5 Flip the unit back over so the display
screen is facing up.
6 Lift the casting up while pushing down on
the rubber boot that runs around the edge
of the LCD screen.
7 Remove the copper tape from the casting.
Note: During reassembly, apply new
copper tape for grounding.
8 Disconnect the LCD display cable
connectors from the back of the LCD
screen to release it.
9 Remove the Kapton tape from the display
cable.
boot
copper tape
cable connectors
Kapton tape