ZOLL Propaq M Rev A User Manual
Page 56
Advertising
52
9650-0804-01 Rev. A
3
Disconnect multi-wire IBP cable with ferrite
in the area illustrated.
4
Cut the tie wrap to the IBP cable in the area
shown with the orange stick.
Note: During reassembly, secure a new tie
wrap to the IBP cable.
5
Disconnect the USB flex cable from ZIF
connector in the area illustrated.
6
Lay front end of separated unit down with
opened side facing up.
7
Disconnect the black EtCO
2
tube
connector from the air vent.
8
Remove four (4) screws in the areas
illustrated to release the silver EtCO
2
module.
Note: During reassembly, torque screws to
6 in-lbs.
multi-wire IBP cable
Advertising