Yokogawa DO402 Dissolved Oxygen Analyzer - Manual (Page 39)

IM 12J05D02-01E
Parameter setting 5-3
5-1-2. Manual Wash start/stop
NO YES
AIR.CAL
YES NO
MODE
NO
NO
NO
NO
NO
NO
NO YES NO YES
YES
MODE
YES
NO
Note: Wash must first be switched on in commissioning mode section 5.5.
and set for adjustment in the maintenance mode, by service code 5.1.
WASH ACTIVE press YES
to stop.
YES
SETPOINTS
RANGE
SET HOLD
SERVICE
MEASURE
NO MODE YES
ENT
S1
S2
WASH/S3
FAIL/S4
YOKOGAWA
MODE
WASH
CONTACTS
MARKINGS
WITHIN
ENCLOSURE
Note:
Relay S3 must first be set for “WASH” in service code 42
Manual wash start/stop is enabled with Service code 51.
Refer to commissioning mode section 5-2-4 for automatic cycle timing setup.
Manual temperature adjustment menu is added to the maintenance mode
Manual temperature adjustment is only visible if the manual temperature in service code 13 is enabled.
When the manual temperature is entered, set the manual temperature and press enter.