Badger Meter SRD/SRI Valve Positioners User Manual
User manual, Valve positioners
Advertising
Table of contents
Document Outline
- Introduction
- What is FDT / DTM?
- Contents of VALcare Software
- Installation
- Starting PACTware
- Opening a Project
- Menu Structure
- Startup
- Measured Value
- Simulation
- Configuration / Parameter
- Identifier Page
- Parameters Page
- Configuration Page
- Characterization Page
- Travel Page
- Alarms Page
- Tuning Page
- Options Page
- Position Transmitter Signal (Pos. Transmitter)
- Alarm Link
- Binary Input
- Binary Output
- Maintenance – History Interval
- Partial Stroke Test
- Pressure Sensors
- Friction / Load Factor
- LCD
- Calibration Menu
- Diagnostics
- Additional Functions
- Status Bits
- Diagnostic Status
- Additional Status
- High Alarm
- High High Alarm
- Low Alarm
- Low Low Alarm
- Cycle Count Limit
- Travel Sum Deadband
- Travel Sum Limit
- Control Difference Limit
- Control Difference Time
- Alarm Deadband
- Internal Electronics Temperature Lower Limit
- Internal Electronics Temperature Upper Limit
- Pressure Sensor Page
- Options Page
- Check Sum
- Measurement Value
- Setpoint
- Position
- Valve Position
- Stem Setpoint
- Air Supply Pressure Reading
- Output Pressure Reading
- Control Difference
- Travel Position
- Travel Sum
- Internal Electronics Temperature
- Cycle Count
- Local Enable
- Analog Setpoint Low
- Analog Setpoint High
- Fabrication Number
- Hardware Revision
- Simulation Value
- Profibus Configurations
- Foundation Fieldbus Configurations