AIS Router AI2524 User Manual
Page 11
AI2524 Router Card User’s Manual
August 1997
TOC-7
2524UM
Set the X.25 Mode .........................................................................................12-2
Set the Virtual Circuit Ranges .......................................................................12-3
Example: Virtual Circuit Ranges ...................................................................12-4
Set the Packet Numbering Modulo ................................................................12-5
Set the X.121 Address....................................................................................12-5
Set the Default Flow Control Values .............................................................12-6
Example: Typical X.25 Configuration...........................................................12-7
Configure the X.25 Level 3 Timers ...............................................................12-9
Configure X.25 Addresses .............................................................................12-10
Establish a Default Virtual Circuit Protocol .................................................. 12-12
Disable Packet-Level Protocol (PLP) Restarts .............................................. 12-13
Configure Subinterfaces.................................................................................12-14
Example: Point-to-Point Subinterface Configuration ....................................12-16
Map Protocol Addresses to X.121 Addresses ................................................ 12-16
Map Datagram Addresses to X.25 Hosts....................................................... 12-18
Establish an Encapsulation PVC....................................................................12-20
Example: PVC Used to Exchange IP Traffic................................................. 12-21
Set X.25 TCP/IP Header Compression ..........................................................12-22
Configure X.25 Bridging ...............................................................................12-22
Configure X.25 Payload Compression ..........................................................12-23
Configure the Encapsulation Virtual Circuit Idle Time ................................. 12-24
Increase the Number of Virtual Circuits Allowed ......................................... 12-25
Configure the Ignore Destination Time ......................................................... 12-25
Establish the Packet Acknowledgment Policy...............................................12-25
Configure X.25 User Facilities ......................................................................12-26
Define the Virtual Circuit Packet Hold Queue Size ......................................12-28
Restrict Map Usage........................................................................................12-28
Enable X.25 Routing......................................................................................12-30
Example: X.25 Route Address Pattern Matching .......................................... 12-30
Configure a Local X.25 Route .......................................................................12-31
Example: X.25 Routing .................................................................................12-32
Configure XOT (Remote) X.25 Rout ...........................................................12-33
Configure a Locally Switched PVC ...............................................................12-34
Example: PVC Switching on the Same Router.............................................. 12-34
Example: Simple Remote PVC Tunneling .................................................... 12-35
Configure an XOT (Remote) PVC ................................................................12-35
Example: Remote PVC Tunneling.................................................................12-36
Configure XOT to Use Interface Default Flow Control Values .................... 12-38