AIS Router AI2524 - Manual (Page 49)

Chapter 4: Understanding the User Interface
August 1997 Page 4-13
2524UM
Router(config)# interface serial 0
Router(config-if)# ?
Interface configuration commands:
access-expression Build a bridge boolean access expression
apollo Apollo interface subcommands
appletalk Appletalk interface subcommands
arp Set arp type (arpa, probe, snap) or timeout
backup Modify dial-backup parameters
bandwidth Set bandwidth informational parameter
bridge-group Transparent bridging interface parameters
clns CLNS interface subcommands
clockrate Configure serial interface clock speed
custom-queue-list Assign a custom queue list to an interface
decnet Interface DECnet config commands
delay Specify interface throughput delay
description Interface specific description
dialer Dial-on-demand routing (DDR) commands
dialer-group Assign interface to dialer-list
down-when-looped Force looped serial interface down
encapsulation Set encapsulation type for an interface
ethernet-transit-oui Token-ring to Ethernet OUI handling
exit Exit from interface configuration mode
frame-relay Set frame relay parameters
hdh Set HDH mode
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
ipx Novell interface subcommands
isis IS-IS commands
iso-igrp ISO-IGRP interface subcommands
keepalive Enable keepalive
lapb X.25 Level 2 parameters (Link Access Procedure, Balanced)
llc2 LLC2 Interface Subcommands
lnm IBM Lan Manager
locaddr-priority Assign a priority group
loopback Configure internal loopback on an interface
mac-address Manually set interface MAC address
mop DEC MOP server commands
mtu Set the interface Maximum Transmission Unit (MTU)
netbios Use a defined NETBIOS access list or enable name-caching
no Negate a command or set its defaults
ntp Configure NTP
ppp Point-to-point protocol
priority-group Assign a priority group to an interface
pulse-time Enables pulsing of DTR during resets
pup PUP interface subcommands
sdlc SDLC commands
sdllc Configure SDLC to LLC2 translation
shutdown Shutdown the selected interface
smds Modify SMDS parameters
source-bridge Configure interface for source-route bridging
stun STUN interface subcommands
transmit-interface Assign a transmit interface to a receive-only interface