Chapter 16: basic configuration, Connecting to the network, Connecting to an ethernet network – AIS Router AI2524 User Manual
Page 377: Connecting to a wan, Configuring, Chapter 16: basic configuration -1, Connecting to the network -1, Configuring -1, Basic configuration
Chapter 16: Basic Configuration
August 1997
Page 16-1
2524UM
Chapter 16: Basic Configuration
Connecting to the
Network
Connecting to an Ethernet Network
The AI2524 can be connected to an Ethernet network by:
z
Using a straight-through 10BaseT cable to connect the 10BaseT
port to a 10BaseT hub.
z
Using a crossover 10BaseT cable to connect the 10BaseT port to
a PC network interface card.
Connecting to a WAN
z
If you have a 4-wire 56K/64K DSU/CSU module, use a straight-
through RJ-48S-to-RJ48S cable to connect the RJ-48S port to an
RJ48S jack.
z
If you have a FT1/T1 DSU/CSU module, use a straight-through
RJ-48C-to-RJ48C cable to connect the RJ-48C port to an RJ48C
jack.
z
If you have a synchronous serial module, use a transition cable to
connect the synchronous serial port to a modem or DSU/CSU.
Configuring
This chapter describes how to configure the AI2524 router and de-
scribes the following:
z
Booting the Router for the First Time
z
Configuring the Router
z
Specifying the Boot Method
z
Checking the Configuration Settings
This chapter provides just enough information to get the router up and
running. Review the previous detailed configuration chapters for more
information