AIS Router AI2524 - Manual (Page 178)

AI2524 Router Card User’s Manual
Page 9-20 August 1997
2524UM
2. Configure the NET for the routing process.
net network-entity-title
You can assign a meaningful name for the routing process by using the
tag option. You can also specify a name for a NET in addition to an
address. For information on how to assign a name, see
Specify Short-
cut NSAP Addresses .
In interface configuration mode, specify the interfaces that should be
actively routing IS-IS:
clns router isis [ tag ]
Warning: For IS-IS, multiple NETs per router are allowed, with a
maximum of three. However, only one ISIS process is al-
lowed, whether you run it in integrated mode, ISO CLNS
only, or IP only.
Examples: IS-IS Routing Configuration
These examples illustrate the basic syntax and configuration command
sequence for IS-IS routing.
Level1 and Level2 Routing
This example illustrates using the IS-IS protocol to configure a single
area address for Lev el1 and Le vel2 routing:
1. Route dynamically using the IS-IS protocol:
router isis
2. Configure the NET for the process in area 47.0004.004d.0001:
net 47.0004.004d.0001.0000.0c00.1111.00
3. Enable IS-IS routing on ethernet 0:
interface ethernet 0 clns router isis