AIS Router AI2524 - Manual (Page 284)

AI2524 Router Card User’s Manual
Page 12-26 August 1997
2524UM
Configure X.25 User Facilities
The X.25 software provides commands to support X.25 user facilities
(options specified by the creators of the X.25 Recommendation) that
allow you to implement features such as accounting, user identifica-
tion, and flow control negotiation. You can choose to configure facil-
ities on a per-map basis or on a per-interface basis. In the following
list, the
x25 map commands configure facilities on a per-map basis;
the x25 facility commands specify the values sent for all encap-
sulation calls originated by the interface. Routed calls are not affected
by the facilities specified for the outgoing interface.
To set the supported X.25 user facilities, perform one or more of these
tasks in interface configuration mode:
z Select the closed user group.
x25 facility cug group-number
or
x25 map protocol address [ protocol2
address2 [...[ protocol9 address9 ]]] x121-
address cug number
z Set flow control parameter negotiation values to request on outgo-
ing calls.
x25 facility packetsize in-size out-size
or
x25 map protocol address [ protocol2
address2 [...[ protocol9 address9 ]]] x121-
address packetsize in-size out-size
x25 facility windowsize in-size out-size
or
x25 map protocol address [ protocol2
address2 [...[ protocol9 address9 ]]] x121-
address windowsize in-size outsize
z Set reverse charging.
x25 facility reverse
or
x25 map protocol address [ protocol2
address2 [...[ protocol9 address9 ]]] x121-
address reverse