AIS Router AI2524 - Manual (Page 382)

AI2524 Router Card User’s Manual
Page 16-6 August 1997
2524UM
To accept the default answer, press <Enter>; otherwise enter your re-
sponse.
This section gives an example configuration using the System Config-
uration Dialog. When you are configuring your router, respond as ap
propriate for your network.
At any time during the System Configuration Dialog, you can request
help by typing a question mark (?) at a prompt.
Before proceeding with the System Configuration Dialog, obtain from
your system administrator the node addresses and the number of bits
in the subnet field (if applicable) of the Ethernet and synchronous se-
rial ports.
Take these steps to configure the router using the System Configura
tion Dialog:
1. Connect a console terminal to the console connector on the rear
panel of your router, and turn ON power to the router. (For mor
information, refer to the section Connecting the Console Terminal
and Modem in the chapter Installing the Cisco 2524 Routers.)
The default parameters for the console port are 9600 baud, 8 data
bits, no parity, and 2 stop bits.
2. After about 30 seconds, information similar to this is displayed on
the console screen.
The messages displayed vary, depending on the Cisco IOS releas
and feature set you selected. The screen displays in this section are
for reference only and may not exactly reflect the screen displays
on your console.
When you see this information, you have successfully booted your
router: