AIS Router AI2524 - Manual (Page 44)

AI2524 Router Card User’s Manual
Page 4-8 August 1997
2524UM
Router> enable
Password:
Router# ?
Exec commands:
bfe For manual emergency modes setting
clear Reset functions
clock Manage the system clock
configure Enter configuration mode
connect Open a terminal connection
copy Copy a config file to or from a tftp server
debug Debugging functions
disable Turn off privileged commands
disconnect Disconnect an existing telnet session
enable Turn on privileged commands
exit Exit from the EXEC
help Description of the interactive help system
lat Open a lat connection
llc2 Execute llc2 tests
lock Lock the terminal
login Log in as a particular use
logout Exit from the EXEC
menu Start a menu-based user interf
name-connection Name an existing telnet connection
ping Send echo messages
reload Halt and perform a cold restart
resume Resume an active telnet connection
send Send a message to other tty lines
setup Run the SETUP command facility
show Show running system information
systat Display information about terminal lines
telnet Open a telnet connection
terminal Set terminal line parameters
test Test subsystems, memory, and interfaces
tn3270 Open a tn3270 connection
trace Trace route to destination
where List active telnet connections
which-route Do route table lookup and display results
write Write running configuration to memory, network, or
terminal
x3 Set X.3 parameters on PAD
xremote Enter XRemote mode
ROM Monitor Mode Commands
If your router or access server does not find a valid system image, or
if you interrupt the boot sequence, the system might enter ROM mon-
itor mode. From ROM monitor mode, you can boot the device or per-
form diagnostic tests.