AIS Router AI2524 - Manual (Page 222)

AI2524 Router Card User’s Manual
Page 9-64 August 1997
2524UM
Configure Miscellaneous TARP PDU Information
TARP default PDU values typically do not need to be changed.
You can configure the sequence number of the TARP PDU, set the up-
date remote cache bit used to control whether the remote router up
dates its cache, specify the N-selector used in the PDU to indicate
TARP PDU, and specify the network protocol type used in outgoing
PDUs.
In global configuration mode, configure miscellaneous PDU informa-
tion:
1. Change the sequence number in the next outgoing TARP PDU.
tarp sequence-number number
2. Set the update remote cache bit in all subsequent outgoing TARP
PDUs so that the remote router does or does not update the cache.
tarp urc [0 | 1]
3. Specify the N-selector used to identify TARP PDUs.
tarp selector hex-digit
4. Specify the protocol type used in outgoing TARP PDUs. Only FE
(to indicate CLNP) is supported.
tarp protocol hex-digit
Monitor and Maintain the TARP Protocol
Use these EXEC commands to monitor and maintain the TARP
caches, tables, and databases:
z Reset the TARP counters that are shown with th show tarp
traffic command.
clear tarp counters
z Remove all system ID-to-sequence number mapping entries in the
TARP loop detection buffer table.
clear tarp ldb-table
z Remove all dynamically created TARP TID-to-NSAP address
mapping entries in the TID cache.
clear tarp tid-table
z Display all global TARP parameters.
show tarp