Example: multilink ppp on one isdn interface – AIS Router AI2524 User Manual
Page 248
AI2524 Router Card User’s Manual
Page 11-22
August 1997
2524UM
Example: Multilink PPP on One ISDN Interface
This example enables Multilink PPP on the BRI 0 interface. Because
an ISDN interface is a rotary group by default, when one BRI is con-
figured, no dialer rotary group configuration is required.
interface bri 0
description connected to ntt 81012345678902
ip address 7.1.1.7 255.255.255.0
encapsulation ppp
dialer idle-timeout 30
dialer load-threshold 40 either
dialer map ip 7.1.1.8 name atlanta 81012345678901
dialer-group 1
ppp authentication pap
ppp multilink
Configure Multilink PPP on Multiple ISDN BRI Interfaces
To enable Multilink PPP on multiple ISDN BRI interfaces, set up a di-
aler rotary interface and configure it for Multilink PPP and then con
figure the BRIs separately and add them each to the same rotary group.
Beginning in global configuration mode, set up the dialer rotary inter-
face for the BRI interfaces:
1.
Specify the dialer rotary interface.
interface dialer
number
2.
Specify the protocol address for the dialer rotary interface.
ip address
address mask
3.
Enable PPP encapsulation.
encapsulation ppp
4.
Specify in-band dialing.
dialer in-band
5.
Specify the dialer idle timeout period, using the same timeout pe-
riod as the individual BRI interfaces.
dialer idle-timeout
seconds