AIS Router AI2524 User Manual
Page 179
Chapter 9: AI2524 OSI/CLNP Configuration Steps
August 1997
Page 9-21
2524UM
4.
Enable IS-IS routing on ethernet 1:
interface ethernet 1
clns router isis
5.
Enable IS-IS routing on serial 0:
interface serial 0
clns router isis
Level2 Routing Only
This example illustrates a similar configuration, featuring a single area
address being used for specification of Level 1 and Level2 routing.
However, in this case, interface serial interface 0 is configured for
Level 2 routing only. Most comment lines have been eliminated from
this example to avoid redundancy.
router isis
net 47.0004.004d.0001.0000.0c00.1111.00
interface ethernet 0
clns router isis
interface ethernet 1
clns router isis
interface serial 0
clns router isis
1.
Configure a level 2 adjacency only for interface serial 0:
isis circuit-type level-2-only
OSI Configuration
This example illustrates an OSI configuration example. In this exam-
ple, IS-IS runs with two area addresses, metrics tailored, and different
circuit types specified for each interface. Most comment lines have
been eliminated from this example to avoid redundancy.
1.
Enable IS-IS routing in area 1:
router isis area1