HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 120)

120 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
Viewing
Scheduled Jobs
The Setup: Scheduled Jobs page lists the completed, pending, inactive jobs. It also lists
jobs that were not completed because of an error. Jobs are CLI commands that are
scheduled to execute at a time you specify. You can only schedule software upgrades
using the Management Console; for all other jobs you must use the CLI.
For detailed information about scheduling jobs using the CLI, see the HP
StorageWorks Enterprise File Services WAN Accelerator Command Line-Interface
Reference Manual.
To view scheduled
jobs 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
2. Click Scheduled Jobs in the left menu to display the Setup: Scheduled Jobs page.
Figure 2-55. Setup: Scheduled Jobs Page
TIP: To remove a scheduled job, click the check box next to the name and click Cancel/
Remove Selected Jobs. Click Save to write your settings to memory or click Reset to return
your settings to their previous values.
Managing Configurations
The following section describes how to save, import, and activate configurations for
the HP EFS WAN Accelerator.
Writing
Configurations
to Memory
Each HP EFS WAN Accelerator has an active, running configuration and written,
saved configurations. You can save your settings on each individual page of the
Management Console or you can apply your settings to make sure that the values you
set are correct before you save the configuration.