HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 30)

30 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
1. You configure in-path rules to apply to all VLANs or to a specific VLAN. By
default, rules apply to all VLAN values unless you specify a particular VLAN Tag
Identification Number (ID). Pass-through traffic maintains any pre-existing
VLAN tagging between the LAN and WAN interfaces.
2. You set the in-path interfaces, VLAN tag IDs to define the VLAN tag that the HP
EFS WAN Accelerator uses to communicate with other HP EFS WAN
Accelerators. For detailed information, see
“Setting In-Path Interfaces” on
page 49 .
NOTE: The HP EFS WAN Accelerator does not support the Cisco InterSwitch Link (ISL)
protocol.
To set an in-path, auto-
discover rule 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
2. Click In-Path Rules in the left menu to display the Setup: Optimization Service -
In-Path Rules page.
Figure 2-3. Setup: Optimization Service - In-Path Rules Page, Auto-Discover Rule
3. Under Add New Rule, select Auto Discover from the Type drop-down list.