HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 74)

74 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
10. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
TIP: To remove a service port, click the check box next to the name and click Remove Selected
Ports. This action applies the settings to the running configuration. Click Save to write your
settings to memory or click Reset to return the settings to their previous values.
TIP: To set a service port as the default port, check the check box next to the port name and
click Set as Default Port.
Enabling WCCP
Groups
Optionally, you can set WCCP service groups in the Setup: Advanced Networking -
WCCP Service Groups page. WCCP enables you to redirect traffic through an HP EFS
WAN Accelerator that is not in the direct physical path between the client and the
server.
TIP: You can also use the HP EFS WAN Accelerator CLI to configure WCCP service groups.
For detailed configuration information (including configuring the WCCP router), see the HP
StorageWorks Enterprise File Services WAN Accelerator Deployment Guide.
NOTE: The following section assumes you are familiar with WCCP. For detailed information
about WCCP, see the Cisco documentation Web site at
http://www.cisco.com/univercd/home/home.htm.
To enable WCCP, the HP EFS WAN Accelerator must join a service group at the
router. A service group is a group of routers and HP EFS WAN Accelerators which
define the traffic to redirect, and the routers and HP EFS WAN Accelerators the traffic
goes through.
WCCP Parameters The following table summarizes the parameters you set for WCCP support.
Field Description
Service Group ID Specifies the service group ID (from 0 to 255). The service
group ID is the number that is set on the router. A value of 0
specifies the standard http service group.
Router IP The router IP is a multicast group IP address or a unicast
router IP address. A total of 32 routers can be specified.
(After you have created a new service group, click the
service group name to add additional routers.)
Flags Specifies the combination of source and destination ports
that the router hashes on and if certain ports should be
redirected.
Ports Specifies up to seven ports that the router redirects.