HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 56)

56 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
5. Under Add New Route, type the destination IP address in the Destination text box.
6. Type the netmask in the Netmask text box.
7. Type the IP address for the gateway in the Gateway text box. This is your WAN
gateway.
8. Click Add Route to add the route to the network routing list and apply your
settings to the running configuration.
9. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
TIP: To remove an in-path route, select the route and click Remove Selected Routes. This
action applies the settings to the running configuration. Click Save to write your settings to
memory or click Reset to return the settings to their previous values.
Setting the DNS
During the initial setup of the HP EFS WAN Accelerator you specified the primary
Domain Name Service (DNS) server and domain for the HP EFS WAN Accelerator.
Check or modify your settings in the Setup: Host Settings - DNS Settings page.
NOTE: HP recommends you configure the Setup: Host Settings - DNS Settings page.
You can also set secondary and tertiary DNS name servers in the Setup: Host Settings
- DNS Settings page.
You can provide additional domains for which the HP EFS WAN Accelerator can
search. If you specify domains under Domain Search, in the Domains text box, the HP
EFS WAN Accelerator automatically finds the appropriate domain for each of the
hosts that you enter in the system.
To set the DNS server 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
2. Click Host Settings in the left menu to display the Setup: Host Settings - Interface:
Primary page.