HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 33)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 33
2 -
C
ON
FIG
URING
TH
E
HP
EF
S
WA
N
A
C
C
EL
ER
ATO
R
8. If you have a backup, out-of-path HP EFS WAN Accelerator in your system
(failover support), type the IP address and port for the backup appliance in the
Backup IP and Port text boxes. Use the following format: 0.0.0.0/0. The default
port is 7810.
9. Optionally, under Advanced Options, select the VLAN identification number from
the VLAN Tag ID drop-down list to set the VLAN tag ID. All specifies the rule
applies to all VLANs; Untagged specifies the rule applies to non-tagged
connections.
10. Optionally, select Normal, SDR-Only, or None from the Optimization Policy
drop-down list to set the optimization policy for this rule.
11. Optionally, select Never, Always, TCP Hints, or Dynamic from the Neural
Framing drop-down list to set the neural framing mode for this rule.
12. Click Add Rule to apply the rule to the running configuration.
13. Optionally, under Additional Options, click Enable Computation of Neural
Heuristics to enable the HP EFS WAN Accelerator to select the optimal packet
framing boundaries for SDR.
14. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
TIP: To remove a rule, click the check box next to the name and click Remove Selected Rules.
This action applies the settings to the running configuration. Click Save to write your settings to
memory or click Reset to return the settings to their previous values.
To set a pass-through
rule 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
2. Click In-Path Rules in the left menu to display the Setup: Optimization Service -
In-Path Rules page.