HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 32)

32 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
Figure 2-4. Setup: Optimization Service - In-Path Rules Page, Fixed-Target Rules
3. Under Add New Rule, select Fixed-Target from the Type drop-down list.
4. Select start, end, or a rule number from the Insert Rule At drop-down list to insert
a rule in the Rules list. When you specify a particular rule number, the rule is
placed after the rule number you specified and before the default auto-discovery
rule.
5. Type the IP address for the source subnet in the Source Subnet text box. Use the
following format: 0.0.0.0/0.
6. Type the IP address, port, or port label in the Destination Subnet and Port text
boxes. Use the following format: 0.0.0.0/0. To specify all ports, type all in the Port
text box.
7. Under Targets, type the IP address and port number for the HP EFS WAN
Accelerator that is the peer, in the Target IP and Port text boxes. The IP address
must be the Primary Port IP address on the target HP EFS WAN Accelerator. The
default port is 7810.