HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 54)

54 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
8. Type an MTU value in the MTU text box. The MTU is the largest physical packet
size, measured in Bytes, that a network can transmit. The default value is 1500.
9. Click Apply to apply your settings to the running configuration. (Apply your
settings to test a new configuration before committing it to memory.)
10. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
Setting Static
Primary Routes
Optionally, you can configure primary static routes in the Setup: Host Settings -
Routing: Main page for device management or out-of-path network configurations.
Primary static network routes set routing rules in the main routing table for the primary
interface.
To set a static primary
route 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
2. Click Host Settings in the left menu to display the Setup: Host Settings - Interface:
Primary page.
3. Click Routing: Primary in the left menu to display the Setup: Host Settings -
Routing: Main page.
Figure 2-16. Setup: Host Settings - Routing: Main Page
4. Under Add New Route, type the destination IP address in the Destination text box.
5. Type the netmask in the Netmask text box.
6. Type the IP address for the gateway in the Gateway text box.