HP Color LaserJet 5550 Printer series - Manual (Page 104)

6. Close the tray.
7. The printer displays the tray size and type configuration
8. If the size and type are correct, press to accept the settings, and exit the message.
9. To change the size or type, press when the tray configuration is displayed (If the tray
configuration is no longer displayed, open and close the tray again). The TRAY X SIZE=
*<SIZE> menu appears.
10. Press or to highlight the correct size.
11. Press to select the size. A Setting saved message appears followed by the tray type
menu.
Note Depending on the size selected, the printer might prompt you to move the CUSTOM/
STANDARD switch in Tray to another position or to move the length/width guides. Follow the
instructions in the prompt, close the tray, and follow these steps from the beginning.
12. To change the type, press or to highlight the correct paper type.
13. Press to select the paper type. A Setting saved message appears, and then the
current type and size settings are displayed again.
14. If size and type are now correct, press to accept the size and type settings, and exit
the message. The tray is ready to use.
Loading custom media into Trays 2, 3, 4, and 5
Follow this procedure to load custom size paper in the tray.
CAUTION To avoid jams, never add or remove a tray during printing.
CAUTION The paper path for Tray 3 passes through Tray 2. If Tray 2 is partially pulled out or removed,
paper from Tray 3 cannot feed into the printer. This causes the printer to stop and generate
a message that Tray 2 must be installed. Similarly, Trays 2, 3, and 4 must be closed for
paper from Tray 5 to feed into the printer.
CAUTION Do not print cardstock, envelopes, or unsupported sizes of media from Tray 2, 3, 4, or 5.
Print on these types of media only from Tray 1. Do not overfill the input tray or open it while it
is in use. Doing so can cause paper jams.
90 Chapter 4 Printing tasks ENWW