HP Color LaserJet 5550 Printer series User Manual
Page 260
Advertising
5. Slide out the formatter board and set it on a clean, flat, grounded surface.
6. Align the groove on the side of the flash memory card with the notches in the connector
and push it in the slot until it is fully seated.
CAUTION
Do not insert the flash memory card at an angle.
Note
The first flash memory slot marked "Firmware Slot" is reserved for firmware only. Slots 2 and
3 should be used for all other solutions.
7. Align the formatter board in the tracks at the top and bottom of the slot, and then slide
the board back into the printer. Replace and tighten the eight screws removed in step 4.
246
Appendix A Working with memory and print server cards
ENWW
Advertising