HP Color LaserJet 5550 Printer series - Manual (Page 186)

Control panel message Description Recommended action
Printing...
USAGE PAGE
The printer is generating the usage
page. The printer will return to the online
Ready state when the page is completed. No action necessary.
Processing duplex
job
Do not grab paper
until job completes
Paper temporarily comes into the output
bin while printing a duplex job. Do not
attempt to remove the pages until the job
is complete. Do not grab paper as it temporarily
comes into the output bin. The message
will disappear when the job is finished.
Processing... The printer is currently processing a job
but is not yet picking pages. When paper
motion begins, this message will be
replaced by a message that indicates
which tray the job is being printed from. No action necessary.
Processing...
copy <X> of <Y>
The printer is currently processing or
printing collated copies. The message
indicates that copy X of Y total copies is
currently being processed. No action necessary.
Processing...
from tray xx
The printer is actively processing a job
from the designated tray. No action necessary.
RAM DISK DEVICE
FAILURE
To clear press
alternates with
Ready
A device failure has occurred on the
specified drive. 1. To clear the message, press the
key.
2. If the message persists, turn the
printer off and then back on.
3. If the message still persists, contact
HP Support.
RAM DISK FILE
OPERATION FAILED
To clear press
alternates with
Ready
The printer received a PJL file system
command that attempted to perform an
illogical operation (for example, to
download a file to a non-existent
directory).
Printing may continue.
1. To clear the message, press the
key.
2. If the message persists, turn the
printer off and then back on.
3. If the message reappears, there
may be a problem with the software
application.
RAM DISK FILE
SYSTEM IS FULL
To clear press
alternates with
Ready
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system is
full. 1. To clear the message, press the
key.
2. If the message persists, turn the
printer off and then back on.
Note
This will also delete any files saved in
RAM.
RAM DISK IS
WRITE PROTECTED
To clear press
alternates with
Ready
The file system device is protected and
no new files can be written to it. 1. To enable writing to the RAM disk,
turn off write protection, using
HP Web Jetadmin software.
2. To clear the message, press the
key.
3. If the message persists, turn the
printer off and then back on.
Control panel messages (continued)
172 Chapter 8 Problemsolving ENWW