HP Color LaserJet 5550 Printer series User Manual
Page 193
Control panel message
Description
Recommended action
TRAY XX SIZE=<SIZE>
Recommend move switch to
STANDARD
alternates with
TRAY XX SIZE=<SIZE>
Then close tray
A detectable media size was selected
from the menu and the tray is open.
Although not required, the size selected
can be automatically sensed if the tray
switch is moved to STANDARD.
1.
Adjust the side and rear media
guides against the paper.
2.
If the media used is letter, A4,
executive, JIS B5, A5, or legal, the
tray switch should be set to
STANDARD. Set the tray switch to
CUSTOM for all other media sizes.
The tray switch must be set before
the size can be selected from the
control panel.
TYPE MISMATCH IN
TRAY X
For help press
alternates with
Ready
The media type loaded in the tray does
not match the media type configured for
the tray.
1.
Adjust the side and rear guides
against the paper.
2.
If size is a detectable size, set the
tray switch to STANDARD,
otherwise set the tray switch to
CUSTOM.
3.
If necessary, press after the tray
is closed to change the paper size
or type.
Unable To Mopy Job
alternates with
Processing...
A Mopy job cannot be mopied because
of a memory, disk, or configuration
problem. Only one copy will be produced.
Install additional memory in the printer or
install a disk drive in the printer.
Unable To Store Job
alternates with
Processing...
A job cannot be stored because of a
memory, disk, or configuration problem.
Install additional memory in the printer,
or install a disk drive into the printer. If a
disk drive is installed, delete previously
stored print jobs.
USE TRAY X
<TYPE> <SIZE>
Size detected by tray
alternates with
Tray X
<TYPE> <SIZE>
To change size or type
press
The printer is reporting the current
configuration of tray X. The tray switch is
in the STANDARD position.
1.
If the configuration of the size and
type is correct, press
to clear
the message.
2.
To change media size or type, press
.
Use and to highlight the size or
type, and then press to select.
3.
If action is required to change the
size, a message with instructions
will appear after the selection is
attempted.
USE TRAY X
<TYPE> <SIZE>
To change press /
To use press
The printer is offering a selection of
alternate media to use for the print job.
1.
View tray configurations (type and
size) using and .
2.
Press to select a tray to use.
Wait for printer
to reinitialize
RAM disk settings have been changed
before the printer automatically restarts,
or external device modes have changed
or the printer is coming out of the
diagnostics mode and will automatically
restart.
No action necessary.
Control panel messages (continued)
ENWW
Control panel messages
179