HP Color LaserJet 5550 Printer series - Manual (Page 79)

6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to highlight MANUAL SETTINGS.
10. Press to select MANUAL SETTINGS.
11. Press to highlight SYSLOG SERVER.
12. Press to select SYSLOG SERVER.
Note The first of four sets of numbers are the default settings. Each set of numbers represents
one byte of information and has a range from 0 to 255.
13. Press the or arrow to increase or decrease the number for the first byte of the
default gateway.
14. Press to move to the next set of numbers. (Press to move to the previous set of
numbers.)
15. Repeat steps 13 and 14 until the correct subnet mask is entered.
16. Press to save the syslog server.
17. Press the M
ENU
button to return to the Ready state.
Setting the local and default gateway
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to highlight MANUAL SETTINGS.
11. Press to select MANUAL SETTINGS.
12. Press to highlight LOCAL GATEWAY or DEFAULT GATEWAY.
13. Press to select LOCAL GATEWAY or DEFAULT GATEWAY.
Note The first of three sets of numbers are the default settings. If there is not a number
highlighted, a highlighted empty underscore appears.
14. Press or to increase or decrease the number for configuring LOCAL or DEFAULT
GATEWAY.
15. Press to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct subnet mask is entered.
17. Press the M
ENU
button to return to the Ready state.
ENWW Network configuration 65