HP Color LaserJet 5550 Printer series - Manual (Page 81)

10. Press to highlight ENABLE.
11. Press to select ENABLE.
12. Press to highlight ON or OFF.
13. Press to select ON or OFF.
14. Press the M
ENU
button to return to the Ready state.
Setting the idle timeout
1. Press to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to highlight MANUAL SETTINGS.
10. Press to select MANUAL SETTINGS.
11. Press to highlight IDLE TIMEOUT.
12. Press to select IDLE TIMEOUT.
13. Press the or arrow to to increase or decrease the number of seconds for the idle
timeout.
14. Press to save the idle timeout.
15. Press the M
ENU
button to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight LINK SPEED.
9. Press to select LINK SPEED.
ENWW Network configuration 67