HP Color LaserJet 5550 Printer series - Manual (Page 66)

Changing printer control panel configuration settings
By using the printer control panel, you can make changes to general printer configuration
default settings such as tray size and type, PowerSave Time, printer personality (language),
and jam recovery.
The printer control panel can also be accessed from a computer by using the setting page of
the embedded Web server. The computer shows the same information that the control panel
shows. For more information, see
Using the embedded Web server .
CAUTION Configuration settings seldom need to be changed. Hewlett-Packard recommends that only
the system administrator change configuration settings.
Job storage limit
This option sets the limit for the maximum number of jobs stored on the hard drive at the
printer. The maximum number allowed is 100, and the default value is 32.
Note This option is only available if a hard drive is installed.
To set the job storage limit
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to select JOB STORAGE LIMIT.
7. Press or to change the value.
8. Press to set the value.
9. Press M
ENU
.
Job held timeout
This option sets the period of time that the system keeps files in job storage before deleting
them from the queue. The default setting for this option is OFF; the other available settings
are 1 HOUR, 4 HOURS, 1 DAY, and 1 WEEK.
Note This option is only available if a hard drive is installed.
To set the job held timeout
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
52 Chapter 2 Control panel ENWW