HP Color LaserJet 5550 Printer series - Manual (Page 80)

Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols
has the following benefits:
● decreases printer-generated network traffic
● prevents unauthorized users from printing to the printer
● provides only pertinent information on the configuration page
● allows the printer control panel to display protocol-specific error and warning messages
Note TCP/IP configuration cannot be disabled on the HP Color LaserJet 5550 series printer.
To disable IPX/SPX
Note Do not disable this protocol if Windows 95/98, Windows NT, ME, 2000, and XP users will be
printing to the printer.
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight IPX/SPX.
9. Press to select IPX/SPX.
10. Press to highlight ENABLE.
11. Press to select ENABLE
12. Press to highlight ON or OFF.
13. Press to select ON or OFF.
14. Press the M
ENU
button to return to the Ready state.
To disable DLC/LLC
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight DLC/LLC.
9. Press to select DLC/LLC.
66 Chapter 3 I/O Configuration ENWW