HP Color LaserJet 5550 Printer series - Manual (Page 72)

Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default
value.
● CONTINUE allows the printer to continue printing while displaying a warning until the
supply is replaced.
● STOP causes the printer to pause printing until you replace the used supply or press ,
which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight SUPPLIES LOW.
7. Press to select SUPPLIES LOW.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
Color supply out
There are two options for this menu item.
● autoContinueBlack allows the printer to continue printing using black toner only when a
color supply is empty. A warning message displays on the control panel when the printer
is in this mode. Printing in this mode is allowed only for a specific number of pages. After
that, the printer will pause printing until you replace the empty color supply.
● STOP causes the printer to stop printing until the empty color supply is replaced.
To set color supply out response
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight COLOR SUPPLY OUT.
7. Press to select COLOR SUPPLY OUT.
8. Press or to select the appropriate setting.
9. Press to set the selection.
10. Press M
ENU
.
58 Chapter 2 Control panel ENWW