HP Color LaserJet 5550 Printer series - Manual (Page 78)

10. Press to select MANUAL SETTINGS.
11. Press to highlight MANUAL.
12. Press to highlight IP ADDRESS.
13. Press to select IP ADDRESS.
Note The first of three sets of numbers is highlighted. If there is not a number highlighted, a
highlighted empty underscore appears.
14. Press or to increase or decrease the number for configuring the IP address.
15. Press to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct IP address is entered.
17. Press the M
ENU
button to return to the Ready state.
Setting the subnet mask
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to highlight MANUAL SETTINGS.
11. Press to select MANUAL SETTINGS.
12. Press to highlight SUBNET MASK.
13. Press to select SUBNET MASK.
Note The first of three sets of numbers is highlighted.
14. Press or to increase or decrease the number for configuring the subnet mask.
15. Press to move to the next set of numbers.
16. Repeat steps 14 and 15 until the correct subnet mask is entered.
17. Press the M
ENU
button to return to the Ready state.
Setting the syslog server
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
64 Chapter 3 I/O Configuration ENWW