HP Photosmart C4344 All-in-One Printer User Manual

Page 185

Advertising

both devices will answer the call and fax tones will be recorded on the answering
machine.
Set your answering machine to a low number of rings and the product to answer in
the maximum number of rings supported. (The maximum number of rings varies by
country/region.) In this setup, the answering machine will answer the call and the
product will monitor the line. If the product detects fax tones, the product will receive
the fax. If the call is a voice call, the answering machine will record the incoming
message.
For more information on setting up the product when you have an answering machine,
see the printed documentation that came with the product.
For more information, see:

“Choose the recommended answer setting for your setup” on page 19

Cause: The answering machine was not set up properly with the product or the
number or rings to wait setting was not correct.
If this did not solve the issue, try the next solution.

Solution 2: Set up the product to answer faxes automatically

Solution: Set up the product to answer incoming calls automatically by turning on
Auto Answer. If it is turned off, the product will not monitor incoming calls and receive
faxes. In this case, the answering machine will answer the fax call and record the fax
tones.
For more information on setting up the product when you have an answering machine,
see the printed documentation that came with the product.
Cause: The product was set up to receive faxes manually, which means that the
product would not answer incoming calls. You must be available to respond in person
to incoming fax calls, or the product will not receive the fax and your answering
machine will record the fax tones.

The product cannot receive faxes, but can send faxes

Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.

•

Solution 1: Make sure you set up the product as described in the printed
documentation

•

Solution 2: Check the Auto Answer setting

•

Solution 3: Set the product to answer faxes manually

•

Solution 4: If you have a computer dial-up modem on the same phone line as the
product, make sure the modem software is not intercepting the fax

•

Solution 5: If you have an answering machine on the same phone line as the product,
record a new outgoing message

•

Solution 6: If you have an answering machine on the same phone line as the product,
make sure it is connected to the correct port