HP Photosmart C4344 All-in-One Printer - Manual (Page 208)

on the back of the product. For more information on setting up the product for
faxing, see the printed documentation.
1 Telephone wall jack
2 Use the phone cord supplied in the box with the product
• If you are using a phone splitter, this can cause faxing problems. (A splitter is a
two-cord connector that plugs into a telephone wall jack.) Try removing the splitter
and connecting the product directly to the telephone wall jack.
• Try connecting a working phone and phone cord to the telephone wall jack that
you are using for the product and check for a dial tone. If you do not hear a dial
tone, contact your telephone company and have them check the line.
• Try to send or receive a test fax. If you can send or receive a fax successfully,
there might not be a problem.
After you resolve any problems found, run the fax test again to make sure it passes
and the product is ready for faxing.
The "Phone Cord Connected to Correct Port on Fax" test failed
Solution: Plug the phone cord into the correct port.
To plug the phone cord into the correct port
1. Using the phone cord supplied in the box with the product, connect one end to
your telephone wall jack, then connect the other end to the port labeled 1-LINE
on the back of the product.
NOTE: If you use the 2-EXT port to connect to the telephone wall jack, you
will not be able to send or receive faxes. The 2-EXT port should only be used
to connect other equipment, such as an answering machine or a telephone.
Fax troubleshooting 205
Trou
bles
ho
ot
ing