Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 100)

Property
Name
Description Valid Values
supported)
• 0-16 Gbps (decimal point
supported)
• none
Default
Traffic
Class Min
Burst Size Specifies the burst
tolerance for the default
traffic class minumum
bandwidth, or for the
default traffic class
maximum bandwidth
when the default traffic
class minimum bandwidth
is none.
This can be set by entering a value using
one the following formats:
• 0-16777216 bytes
• 0~16384 KB (decimal point
supported)
• 0~16 MB (decimal point
supported)
• 0~0.015628 GB (decimal point
supported)
Note - Byte measures can have the value
b,k,kb,m,mb,g,gb (case insensitive)
Default
Traffic
Class
Premarking Specifies the QoS action
to take on the default
traffic class before
bandwidth metering is
applied.
• USEMARKVALUE
• USEDSCP
• none
Default
Traffic
Class
Remarking
Specifies the action to
take after the metering
stage. • USEDSCPMAP
• BWCLASS
• none
Default
Traffic
Class
Storm
Status
Determines whether or
not storm protection is
enabled for the default
traffic class.
• enabled
• disabled
Default
Traffic
Class
Storm
Window Specifies time between
the polling of traffic class
counters that checks
whether storm protection
should be activated. This value can be set by entering a
number from 100-60000.
This can also be set to "none".
Default
Traffic
Class
Storm Rate Storm protection is
activated when this rate of
traffic is exceeded.
Required when storm
protection is enabled.
This value can be set by entering a value
from 1Kbps up to 10Gbps.
The value may contain decimal fractions
up to 3 decimal places.
This can also be set to "none".
Default
Traffic Specifies the action QoS
takes when a storm is • PORTDISABLE
• LINKDOWN
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 100 of 128