Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 89)

Property Name Description Valid Values
• DIAG
• NLSP
• IPXWAN
• any
Destination
IPX Socket Specifies the destination IPX
socket number of an IPX
packet. This can be set by entering a 4-
byte hexadecimal value (0000-
FFFF) or by selecting one of the
following:
• NCP
• SAP
• RIP
• NNB
• DIAG
• NLSP
• IPXWAN
• any
Source TCP
Port Specifies the TCP source port
of a TCP/IP packet. Range: any, 0-65535 or a port
range (n-m).
Destination
TCP Port Specifies the TCP destination
port of a TCP/IP packet. Range: any, 0-65535 or a port
range (n-m).
Source UDP
Port Specifies the UDP source port
of a UDP/IP packet. Range: any, 0-65535 or a port
range (n-m).
Destination
UDP Port Specifies the UDP destination
port of an UDP/IP packet. Range: any, 0-65535 or a port
range (n-m).
Source L4
Mask Specifies the mask or range of
TCP/UDP source ports in the
packet, when you also specify a
single TCP or UDP destination
port number.
This can be set by entering a 4-
byte hex value from 0000-FFFF
Destination L4
Mask
Specifies the mask or range of
TCP/UDP destination ports in
the packet, when you also
specify a single TCP or UDP
destination port number.
This can be set by entering a 4-
byte hex value from 0000-FFFF
L5 Byte Mask
01-16 These parameters each specify
the properties of a single byte
field to match in the Layer 5
part of IP packets, which is the
TCP or UDP payload. For each
byte field you want to match,
specify:
• byteoffset, which is a
Each L5 Byte Mask entry can
be set by entering the following
value:
, ,
(e.g. 3,AA,FF)
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 89 of 128