Allied Telesis AlliedView-EMS 3.10 QoS MANAGER User Manual
Page 48
Property
Name
Description
Valid Values
is to be checked.
Match3
Specifies the actual data to
match
This can be set by entering a 2-
byte hex number. (0000-FFFF)
Mask3
Specifies whether the
corresponding bit in the
Match3 parameter is "on" for a
match or "don't care" for a
match.
This can be set by entering a 2-
byte hex number. (0000-FFFF)
Offset3
Specifies the location or offset
where the pattern for Match3
is to be checked.
Range: 0-62
Protocol
Specifies the protocol of the
packet.
This can be set by selecting any
of the following values:
•
IP
•
IPv6
•
ARP
•
IPX
•
NONIPIPX
•
any
This can also be set by entering
a 1- to 5- byte hexadecimal
value (00-FFFFFFFFFF).
Source TCP
Port
Specifies the TCP source port
of a TCP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
Destination
TCP Port
Specifies the TCP destination
port of a TCP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
TCP Flags
Specifies the TCP flags of a
TCP/IP packet.
This can be set by selecting one
or more of the following values:
•
URG
•
ACK
•
RST
•
SYN
•
FIN
•
any
Source UDP
Port
Specifies the UDP source port
of an UDP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
Destination
UDP Port
Specifies the UDP destination
port of an UDP/IP packet.
Range: any, 0-65535 or a port
range (n-m).
AlliedView™-EMS 3.10 QoS Manager User’s Guide
Page 48 of 128