Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 105)

• When the Protocol property is configured, the Ethernet Format property
should also be configured.
• To configure the Storm Status property, the switch must be in enhanced
mode.
• When the Storm Status property is configured, the Storm Window and
Storm Rate properties should also be configured.
• Values entered for the Storm Window property are automatically
rounded off to the nearest hundreds.
• When the TAG Protocol ID classifier property is not set to any value and
the VLAN classifier property is set to 'any', the current firmware version
automatically sets the TAG Protocol ID to '8100'.
• Values entered for the Length scheduling property are rounded up to the
nearest multiple of 16.
• When the Maximum Bandwidth and Minimum Bandwidth traffic class
properties are set to any of the following values, the current firmware
version automatically converts these values to '16998400 kbps':
o
1600000kbps
o
16000mbps
o
16gbps
When this happens, any attempt to modify the traffic class will result in
the error message: "Invalid value."
• If the Premarking traffic class property is set to 'USEMARKVALUE' and
the Mark Value traffic class property is set to an integer value, they
cannot be configured to 'none' at the same time. Premarking must be
configured to 'none' first before Mark Value can be configured to 'none'.
• If the Default Traffic Class Premarking policy property is set to
'USEMARKVALUE' and the Mark Value policy property is set to an
integer value, they cannot be configured to 'none' at the same time.
Default Traffic Class Premarking must be configured to 'none' first before
Mark Value can be configured to 'none'.
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 105 of 128