Festo Параллельный захват HGP - Manual (Page 25)

HGP−...−A−B(−G..)
Festo HGP−...−A−B(−G..) 0405b English
25
Please note
S Observe the maximum permitted values for:
Ĉ the gripping force (depending on holding force, holding point, eccentricity
and spring force; see catalogue specifications)
Ĉ the maximum permitted weight force of the gripper fingers depending on the
closing time (see Technical specifications).
The weight force of the gripper fingers should be calculated.
Setting the closing time with long and heavy gripper fingers.
S Tighten the restrictor screws of the up−stream GRLA−.../GRLZ−...:
ć at first completely,
ć then loosen one turn.
S Start a test run in the following sequence:
Test run Tests
Without work load Ĉ Correct assignment of the compressed air
connections
Ĉ Gripping speed
Ĉ Function of the proximity switches
With work load Ĉ Reliable holding of the work load
Fig. 18
1. Listen to the knocking of the piston.
Piston knock
Soft Metallic
Tighten the restrictor screw one turn.
The maximum gripping speed is now reached.
Test run with points 2 and 3
continued Finish test run
2. Loosen the restrictor screws of the up−stream GRLA−.../GRLZ−... one turn.
3. Repeat points 1 and 2 until the desired gripping speed is reached.
S Finish the test run. The gripper must then be exhausted.