Konica Minolta eCopy - Manual (Page 158)

150 | Managing eCopy-enabled devices
Publishing connector profiles
You can publish groups of connector profiles to one or more eCopy-enabled devices. You can
publish to ScanStation devices and to devices with embedded clients at the same time.
Publishing prerequisites
Following these rules helps ensure that a published group of connector profiles runs successfully
on the target devices:
■ The source device and the target devices must be in the same domain.
■ File paths that you specify during publishing must be valid on the target devices.
■ The version level of third-party client software, such as Lotus Notes, Microsoft Outlook, and
Captaris RightFax, must be the same on the source device and the target devices.
■ Only connectors whose profiles you select for publishing from the source device should also be
installed on the target devices. The console will report successful publishing for any connector
profiles that are not installed on the target devices, but they will be ignored on the target
device.
■ Make sure that the ShareScan OP Administration console is not running on the target devices.
(If the console is running, an error message will appear in the status column.)
■ The source device cannot be the same as any of the target devices.
The publishing process
Before publishing the profiles, the Administration Console:
■ Makes a copy of all the required files in the Base location specified in the Publish Connector
Profiles window.
■ Creates a folder named “eCopyPublishingInfo” under the Base location folder.
■ Creates backup copies of current connector profiles on the target device, storing the copies in
the <installation_directory>\ShareScanOPManager\BackupConnectorProfiles folder on the
target device.