Konica Minolta eCopy - Manual (Page 23)

eCopy ShareScan OP Installation and Setup Guide | 15
Configuring the touch screen
The UPDD program enables you to configure the touch screen, which includes setting the correct
baud rate and calibrating the screen. The program sets the default baud rate to 19200, which is
required on a new ScanStation.
To calibrate the touch screen:
1 Click Start > Programs > UPDD > Settings . (You can also access the program by selecting
Pointer Devices in Control Panel.) The Pointer Device Properties window opens.
2 Select the Calibration tab, then set the number of calibration points to 9 . (The default is 5 .)
3 Click Calibrate .
4 Follow the calibration instructions on the touch screen.
Important! Older ScanStations use a baud rate of 2400. If you are installing ShareScan OP on an
older ScanStation, do not change the baud rate. You have an older ScanStation if the
model number on the outside of the ScanStation PC is “D530S” or “D510”.