Konica Minolta eCopy - Manual (Page 69)

eCopy ShareScan OP Installation and Setup Guide | 61
Creating and saving connector profiles
You must configure a connector's profile and test the settings before you can activate it for use
with a device.
To create a new profile:
1 In the console tree, select the connector for which you want to create a profile.
2 Specify the Properties settings for the profile and click Save .
The Save Profile window opens.
3 Enter a name for the new profile and click Save .
Your Properties settings are saved for the profile.
4 Specify the Services settings for the profile and click Save .
Your Services settings are saved for the profile.
The profile is configured and available for activation in the Devices > <device name> > Properties
window.
To update an existing profile:
1 In the console tree, select the connector whose profile you want to modify.
2 In the list of profiles, select the profile you want to modify.
3 Update the Properties settings as appropriate, and click Save .
4 In the Save Profile window, select the target profile and click Save .
5 Update the Services settings as appropriate, and click Save .
Your Services settings are saved for the profile.
Note: If you make changes to the Services settings before making changes to the Properties
settings, when you click Save, the Save Profile window opens and you must select the
connector profile at that point.