Konica Minolta eCopy - Manual (Page 172)

164 | Managing and using the client application
Using ShareScan OP connectors
After you create and save connector profiles and activate them on a device, your users use a
connector profile by selecting the profile’s button on the client screen (see “Configuring and
activating connector profiles” on page
22).
The “look and feel” of the client application depends on whether you are using a device with an
embedded client or a device connected to an eCopy ScanStation. This section uses ScanStation
screens to illustrate procedures; if you are not using a ScanStation, your screens will look different.
The screens use the default icons included with ShareScan OP.
This section provides you with a general procedure for using an eCopy connector to scan and send
a document. For information about functions unique to each connector, refer to the connector-
specific information in this guide.
The sequence of some procedures depends on whether you configured the client to use a hard
keyboard or the on-screen keyboard (see “Configuring the keyboard for the ScanStation client” on
page 161).