Aligning and leveling mixer, Remove shipping inserts – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 14
12 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
Aligning and Leveling Mixer
Remove Shipping Inserts
After you have plugged the mixer into a dedicated power line and leveled it, inspect
to be sure that you have removed the shipping materials inside the mixer.
1.
Make sure the front door of the paint mixer is closed.
A safety switch
prevents the operation of the paint mixer while the door is open.
2.
Apply power to the paint mixer by placing the POWER switch in the ON
position.
3.
Turn the button labeled EMERGENCY STOP clockwise until the button pops
out to the ON position.
If the button does not turn, then it is already in
the ON position. To stop or turn off the paint mixer, push the button to
the OFF position.
4.
Push the UP button. Wait several seconds until the top plate raises high
enough for you to remove the shipping inserts.
5.
Open the front door of the paint mixer. Remove the shipping inserts and the
wooden disc insert.
If there is not enough room to remove the inserts,
then push the UP button again.
6.
Be sure that you save the plywood and the foam rubber discs. These will be
used with 5-gallon pails.
7.
Before performing an operational test, read the following information Getting
To Know Your Mixer.