Testing shake motor – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 34
32 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
Read all of the following instructions. If you have any doubt about performing these
procedures, please contact Fluid Management.
For component location and identification, refer to the Parts Section of this manual.
•
WARNING
ELECTRICAL HAZARD
To carry out this test you will need 120 volts which
could cause electrical shock.
Testing Shake Motor Procedure
1.
Place an empty pail on the table and close the door firmly. Turn on the paint
mixer and push the START button. Give the paint mixer enough time to lower
the top plate onto the pail.
2.
Turn off the paint mixer and unplug the electrical cord.
3.
Remove the lower front and right side panels.
4.
Remove the motor cover.
5.
Take a 3-conductor jumper cable, which has a plug at one end and stripped
wires on the other end, and connect the wires to the shake motor.
6.
Plug the jumper cord into a wall outlet (120 volts or appropriate voltage).
• If the shake motor starts to run, then the cable or the relay is bad.
• If the shake motor does not run, it has to be replaced.
7.
Unplug and remove the jumper cord from the shake motor.
8.
Reassemble the mixer by returning the motor cover and lower panel to their
correct positions.
Testing Shake
Motor
Testing Shake Motor