Removing shake frame, Remove the counterweights – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 32
30 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
Removing Shake Frame
•
CAUTION
The inner frames weigh 21 pounds each!
Remove the Counterweights Procedure
1.
Remove the 2 lower inner frame counterweights to access the nuts on the
flange bearings and the rear screws and nuts on the pillow block bearings.
Note: DO NOT REMOVE the 2 upper inner frame counterweights.
Use two 1/2” wrenches, or a ratchet and a 1/2” wrench
to remove the 2 lower nuts and screws holding the lower
weights to the inner frame to allow access to the crankshaft.
2.
With two 1/2” wrenches or a ratchet and a 1/2” wrench, loosen BUT DO NOT
REMOVE the 4 screws securing the flange bearings to the shake frame.
Remove the 4 nuts.
Figure 8. Flange Bearings
Remove the
Counterweights
Flange Bearing
Flange Bearing Screw
washer
Flange Bearing Nut